CoxaPro
> Clinical Library > Welcome to the joint replacement clinical library > The influence of tibial morphology on the design of an anatomical tibial baseplate for TKA
The Knee, ISSN: 1873-5800, Vol: 21, Issue: 2, Page: 415-9
Knee
Link to article
The influence of tibial morphology on the design of an anatomical tibial baseplate for TKA
Hartel, Maximilian J; Loosli, Yannick; Delfosse, Daniel; Diel, Peter; Thali, Michael; Ross, Steffen; Kohl, Sandro; Eggli, StefanKnee
Background
Finding the right balance between tibial coverage and minimal implant overhang is an important factor in TKA. Another significant cause of failure is component malrotation.
Methods
An average master shape of the proximal tibia at TKA resection level was calculated using fine slice computed tomographies of 117 cadaveric knees. To find out whether alternate implant contours would be necessary depending on the patient’s body size, we established five subgroups to compare. CAD-Analysis was performed to simulate the overhang produced after ± 4°/± 7°/± 10° rotation.
Results
A master shape for the tibial resection cut (with a 5° posterior slope, 7 mm under lateral joint line) could be determined. Neither left vs. right knee joint, nor male vs. female nor the size subdivision appears to alter the calculated master shape significantly. The optimized shape allowing for ± 4° of rotational freedom was found to be the best variant.
Conclusions
Valid methods have been obtained to design a two-dimensional average shape of the tibial plateau. The modifications described in this study might come in useful, when designing future implant designs.
Clinical relevance
An optimized fit at the tibial plateau and lower rates of component malrotation may result in better outcomes after TKA.
Link to article