Long-Term Results Using the Anatomic Medullary Locking Hip Prosthesis

Since the introduction of cementless total hip arthroplasty in the early 1980s, concern has shifted from component loosening toward polyethylene wear and osteolysis. The current review of 223 consecutive unselected Anatomic Medullary Locking femoral and acetabular components extends the followup on a series of patients previously reported on at 5 and 10 years. The purposes are to describe the reasons for revisions and to assess the onset and size of osteolytic lesions, with the hypothesis that osteolysis represents an important cause of loosening. The population included 204 patients (211 hips) with mean followup of 13.9 years (range, 2–18 years). Among them, 122 patients (129 hips) had a minimum 15-year followup. Minimum 2-year radiographs with a mean radiographic followup of 12.2 years (range, 2–18 years) were available for 204 hips (197 patients). Of the entire study group, 39 hips (38 patients) had 44 component revisions, increasing the number of revisions by 24 since this series was reported previously. Twenty-six patients (27 hips) had their first revision surgery more than 10 years after the primary surgery. The most common reason for revision of original components was wear or osteolysis occurring in 22 of the 39 hips (21 of 38 patients). The overall loosening rate was 3.4% (seven of 204) for femoral components and 5.4% (11 of 204) for acetabular components. Twenty-four percent of hips (48 of 204) had evidence of femoral or pelvic osteolytic lesions larger than 1.5 cm ² . Femoral osteolysis was not associated with any case of femoral loosening, whereas seven of the 11 loose acetabular components were associated with pelvic lesions larger than 1.5 cm ² .