Dual Mobility and Conventional Bearings Have Comparably Low Dislocation Rates for Anterior-Based Approaches in Total Hip Arthroplasty

Dual mobility (DM) bearings for total hip arthroplasty (THA) have been proposed to reduce the risk of instability in select patients, especially those undergoing revision surgery. The use of DM bearings has not been studied as extensively for use in primary THA. The purpose of this study is to compare outcomes following primary THA with anterior-based approaches between patients receiving DM bearings vs standard bearing hip implants.

We retrospectively reviewed a consecutive series of patients undergoing primary THA through an anterior-based approach. A 3:1 propensity score match was performed between the standard and DM bearing patients to control for possible risk factors for instability. Functional outcomes, dislocations, and aseptic revisions were identified for each patient. The effect of DM on postoperative outcomes was determined using univariate statistical analyses.

In total, 250 DM bearings were compared to 753 standard bearings. We found no difference in dislocation rate between single bearings and DM bearings (0.53% vs 0.4%). There was 1 DM dislocation occurring in a liner with outer diameter of 38 mm. There were no DM dislocations with outer diameter >38 mm. Aseptic revision surgery was more common in DM. This difference was driven by higher incidence of femoral periprosthetic fracture. There were no differences in functional outcomes.

Dislocation rates are comparably low between DM bearings and standard bearings for THA done using an anterior approach to the hip. Further investigation is needed to determine if specific patient populations may benefit from DM implants for primary THA when an anterior approach to the hip is being used.